In Reply to: RE: All mine are DIY... posted by David Pritchard on August 31, 2016 at 06:42:00:
Just purchase two of these cables... First cut the Male end off of both cables... The wires are so small so I used my thumb and finger to strip the wires... The outer casing can be carefully removed with an X-ACTO knife...Now you need to choose a color for the Ground (Not the bare ground in photo) of your Male RCA Plugs You need to purchase two Male RCA Plugs... All the rest of the bundle goes to the Hot on the RCA Male Plug...
When I made mine the wires were so fine, I had no problem getting the bundle soldered to the Hot side of the Male RCA Plug...
If you have done this type of work before, it should take less than an hour to make your set of HDMI Adapters...
All my best to you...:)
Edits: 08/31/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Make your own HDMI Adapter... - RadioWonder 20:54:55 08/31/16 (2)
- The BNC Adapter shown in the photo has a male 75 ohm thread... - RadioWonder 21:25:57 08/31/16 (1)
- Here are your couplers... - RadioWonder 21:32:21 08/31/16 (0)