|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
|
|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
In Reply to: RE: Cable for XLR interconnects posted by RIQUE on June 16, 2016 at 05:44:05:
I hope that this link will help.
The 3 conductor wires do not need to be shielded (only insulated). The cable should have a screen that connects to the connector's case. I have seen cables which use 2 conductors and connect the screen to pin 1 at both ends thus using it for screen and ground. Not recommended.
If you have a cable that has shielded conductors they can be used but then you would need to find a way of connecting the shields to the connector chassis (case) as per the usual screen. Can be done but much more fiddling around.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Cable for XLR interconnects - PAR 06:08:00 06/16/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
