|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
|
|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
In Reply to: BNC and SPDIF posted by lokie on January 22, 2016 at 08:35:33:
Not sure what you asking.
S/PDIF (Sony/Philips Digital Interface Format) is a type of digital audio interconnect used in consumer audio equipment to output audio over reasonably short distances. The signal is transmitted over either a coaxial cable with RCA connectors or a fibre optic cable with TOSLINK connectors. S/PDIF interconnects components in home theatres and other digital high fidelity systems.
S/PDIF is based on the professional AES3 interconnect standard.[1] S/PDIF can carry two channels of uncompressed PCM audio or compressed 5.1/7.1 surround sound (such as DTS audio codec); it cannot support lossless formats (such as Dolby TrueHD and DTS-HD Master Audio) which require greater bandwidth like that available with HDMI or DisplayPort.
S/PDIF is a data link layer protocol and a set of physical layer specifications for carrying digital audio signals between devices and components over either optical or electrical cable. The name stands for Sony/Philips Digital Interconnect Format but is also known as Sony/Philips Digital Interface. Sony and Philips were the primary designers of S/PDIF. S/PDIF is standardised in IEC 60958 as IEC 60958 type II (IEC 958 before 1998).[2]
https://en.wikipedia.org/wiki/S/PDIF
See the Link below for BNC connectors for Belden 1694a coax cable.
Quality? Unknown.
For what it's worth a BNC connector is a true 75 ohm connector.
Most, if not all, digital audio equipment today use RCA jacks.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: BNC and SPDIF - jea48 20:50:01 01/23/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
