In Reply to: Cable re-break in? posted by dave123456@mail.com on September 29, 2015 at 19:42:20:
When enamel insulated magnet wire is implemented for an audio cable, there is so little dielectric involvement that the new solder joint for your re-termination project may take longer to burn-in than the re-burn-in of the wire. That said, it generally takes substantially less time for a previously burned-in cable to settle back into a system if it's not been handled roughly after it's taken out of storage.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Cable re-break in? - Duster 13:29:35 10/01/15 (2)
- RE: Cable re-break in? - wiggy924 19:26:18 10/01/15 (1)
- RE: Cable re-break in? - alan m. kafton 16:56:21 10/06/15 (0)