In Reply to: High quality two-prong power plug? posted by tonyptony on June 17, 2015 at 08:56:43:
Then you can use any cord you want.
Naturally the debate over 'Will grinding down one edge destroy the sonics of the plug" could last for a near eternity.
I would say just be careful to not damage the plating on the flat surface...( done by making certain the grinder is cutting 'down' direction against edge of plating. So turn the plug over to grind other side to keep the cutting so the plating cannot 'lift' off the surface..)Or use a fine file. same thing..
Edits: 06/17/15 06/17/15
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Dremel tool: cut off the ground, and grind down the wider blade. Done. - Smelly_Socks 12:40:45 06/17/15 (4)
- Not a bad idea... - tonyptony 14:19:24 06/18/15 (0)
- I've never seen a 120V 3 wire grounding polarized- - jea48 13:48:26 06/17/15 (2)
- Good call. [nt] - alan m. kafton 15:33:48 06/17/15 (0)
- RE: I've never seen a 120V 3 wire grounding polarized- - Duster 15:20:03 06/17/15 (0)