|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
|
|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
In Reply to: RE: The Terminator posted by mitch2 on February 15, 2015 at 08:23:59:
On this go-round with the BL-Ag IC, I first terminated using Wondersolder, then a fresh XLR with Ag-Cu solder from Chinese seller Vt4c, and finally a fresh XLR with the minimal amount of Ag-Cu solder necessary to mechanically secure the silver wire while allowing unmediated contact between the wire and the gold plated Neutrik socket. Either method using Ag-Cu solder surpasses Wondersolder-- noticeably cleaner sounding. The third method sounds best.
I've considered more expensive XLRs like Furutech. However doing things right(at least conceptually so) would also mean replacing Neutrik chassis connectors all down the line. That's a bit daunting.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: The Terminator - Dave Garretson 08:49:50 02/15/15 (3)
- RE: The Terminator - Ric Schultz 12:24:30 02/15/15 (2)
- Solders - Dave Garretson 13:24:45 02/15/15 (1)
- RE: Solders - Ric Schultz 17:56:31 02/16/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
