Home Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Cable Asylum ]
[ Alert Moderator ]

RE: DIY DC Umbilical for Outboard PSU

Belden 8422 is a 2-conductor cable with a braided shield? Maybe the braided shield is being used as a common ground, while the two central conductors are implemented as two positives for a dual-mono DC wiring scheme? Perhaps the third conductor of the mil-spec wire bundle would replace the braided shield being connected at both ends at this time, and the mil-spec shield would be connected at the power supply end only.

I would expect the 16/3 SPC/PTFE Teflon cable design of the mil-spec cable to sound far better than 22 AWG PVC Belden 8422, but I would need actual specs/information about the PSU wiring scheme before I made any decision.

Let me know if you need further help.

This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]