RE: How to coat bare cu wire to prevent oxidation and...

Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

Posted by Jon Risch (B) on April 21, 2014 at 21:54:21

In Reply to: RE: How to coat bare cu wire to prevent oxidation and... posted by Tweaker456 on April 21, 2014 at 14:11:16:

Not a lot of time, so:

In my opinion, the acrylic sounds the least irritating, followed by the nitrocellulose, and then the nylon. The nylon isn't "bad" mind you, just not as clean and crisp as the other tw.

Some folks might prefer the sound of the nitrocellulose, but it depends a lot on the exact formula and the conditions under which it was applied.
High humidity seems to make all the sprays worse.

Jon Risch

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - How to coat bare cu wire to prevent oxidation and... - Tweaker456 16:16:45 04/19/14 (10)

RE: How to coat bare cu wire to prevent oxidation and... - Jon Risch 20:53:20 04/20/14 (8)

RE: How to coat bare cu wire to prevent oxidation and... - Tweaker456 14:11:16 04/21/14 (2)

RE: How to coat bare cu wire to prevent oxidation and... - kuribo 09:24:41 04/27/14 (0)

RE: How to coat bare cu wire to prevent oxidation and... - Jon Risch 21:54:21 04/21/14 (0)

RE: How to coat bare cu wire to prevent oxidation and... - hum4god 21:43:40 04/20/14 (4)

RE: How to coat bare cu wire to prevent oxidation and... - Tweaker456 14:15:03 04/21/14 (2)

RE: How to coat bare cu wire to prevent oxidation and... - Duster 15:44:30 04/21/14 (1)

RE: How to coat bare cu wire to prevent oxidation and... - davem1 15:57:37 04/21/14 (0)

RE: How to coat bare cu wire to prevent oxidation and... - Duster 08:53:27 04/21/14 (0)

clear lacquer, polyurethane, eptfe tubing, etc. nt - kuribo 17:18:22 04/19/14 (0)

Follow Ups

RE: How to coat bare cu wire to prevent oxidation and... - Jon Risch 21:54:21 04/21/14 (0)

Post a Message!