Home Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

[ Follow Ups ] Thread: [ Display  All  Email ] [ Cable Asylum ]
[ Alert Moderator ]

Re: Getting ready to start JR's 89259/1506a Twisted IC's but a question on the outer braid

Jon,
Would it make any difference if I used 1/8" heat shrink to cover the resister/89259 or outer braid/89259 wires to the ground lug? I would do this just to make sure it couldn't short the wires, or would it adversely affect the sound quality? As for the outer braid, I will get it as close to the connector as possible without shorting out the wires together, to ensure I have the maximum shielding possible.

Thanks again,
Dan

This post is made possible by the generous support of people like you and our sponsors:
  K&K Audio / Lundahl Transformers   [ K&K Audio / Lundahl Transformers Forum ]

Follow Ups Full Thread
Follow Ups
You can not post to an archived thread.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]