Home Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

Re: Inside pics of Aussie wall receptacle

Not surprised at all either.

The Furutech products are amazing as are the Oyaide products.

A good tweak to also do is to solder the electrical wires that feed electricity to your room wherever they are tied together with a wire nut.

Normally, each room is feed from one cable from the CB panel and that cable is daisy chained around the room and is also distributed for the light switches. Solder the wires anywhere they are tied together with wire nuts. This is a much better connection than just relying on the compression of the wire nut.

Also, if only one or a few oulets are used in your listening room, disconnect the ones that are not used where they are daisy chained at the outlets.

Don't forget to use the wire nut after soldering the wires for insulation of the connection.

Disclaimer: If U are not comfortable or have little knowledge about electricity, DO NOT attempt the above procedures.

Cheers,

~kenster


This post is made possible by the generous support of people like you and our sponsors:
  Analog Engineering Associates  


Follow Ups Full Thread
Follow Ups
  • Re: Inside pics of Aussie wall receptacle - kenster 18:00:15 12/11/06 (1)


You can not post to an archived thread.