In Reply to: RE: General tube amp restoration question posted by sony6060 on November 21, 2016 at 08:36:25:
hey Sony. I remember reading your posts a lot over at Audiokarma and really enjoying/learning from them. I also learned a lot working on two fishers. Probably more than other things due to them being a bit picky about what used where. It seemed pretty easy to loose the magic. Getting the output coupling caps right was very hard. I ended up using Mylar film and foils. I have a little x-100-3 that I have to get right.
Anyway, where would you put the poly cap in the power supply and what value? I assume from the output of the voltage doubler to ground.
Thanks.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: General tube amp restoration question - DannyR 22:07:28 11/21/16 (2)
- RE: General tube amp restoration question - sony6060 05:09:11 11/22/16 (1)
- RE: General tube amp restoration question - DannyR 12:02:36 11/23/16 (0)