In Reply to: RE: Samara: Knob caps for Fisher X-202-B? posted by Michael Samra on September 29, 2016 at 01:24:40:
Guys, so what I think I did was purchased the reproduction ones with no marking at all (see link - but I don't recall if that is the party I got mine from. Mine came in a pack of like 6 or 8). And as I look at my knobs I took a fine tip hobby type paint brush with some hobby gloss black paint, and made a very small dot on the bevel - approximately the size of the mark on the other caps. If you look close at the originals, I think that is actually an indenture into the cap. At 1-3 ft, I can not tell the difference. And a whole lot better than no cap. Mike, if you still have the leftover ones I gave you, see if there is a supplier name that you can pass on. They all came stuck to one large piece of paper as I recall. Their real cheap. Hope this helps.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- What I Did - Charlie8521 11:43:08 09/29/16 (0)