In Reply to: RE: 20B posted by banpuku on January 18, 2017 at 16:27:59:
1. The only issue with using the 6C6 triode strapped is that to get near full output, the preamp volume knob needs to be turned all the way up. With the preamp at full throttle, the output is about 90% of max output (just a guess, but close enough for the sake of this conversation). So, is there a way to get the 6C6 triode configuration to get more output from the power amp? If so, how?
If your preamp puts out 17V like you mentioned and your 6C6 is giving a gain of 15 (fair guess for a resistive loaded tube with a mu of 20) then something is seriously amiss if you can get anywhere near full volume on the linestage since 3V into the amp will run the 6C6 into A2 current and clip the output tube.
Your removal of the cathode bypass cap on the 2A3 may be what is "saving you" since the clipping behaviour looks a lot more polite without it in place. (even though the distortion is still upwards of 10%)
In any case, going from tube A with a µ of 20 to tube b with a similar µ isn't going to change your lack of gain.
dave
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 20B - dave slagle 18:57:48 01/18/17 (7)
- RE: 20B - banpuku 06:06:28 01/20/17 (6)
- RE: 20B - dave slagle 16:57:08 01/20/17 (0)
- what is the suppressor grid (pin 4) tied to?..-nt- - elblanco 08:16:47 01/20/17 (4)
- RE: what is the suppressor grid (pin 4) tied to?..-nt- - banpuku 08:32:29 01/20/17 (3)
- RE: what is the suppressor grid (pin 4) tied to?..-nt- - elblanco 08:53:05 01/20/17 (2)
- RE: what is the suppressor grid (pin 4) tied to?..-nt- - banpuku 09:34:37 01/20/17 (1)
- RE: what is the suppressor grid (pin 4) tied to?..-nt- - Tre' 10:36:09 01/25/17 (0)