In Reply to: RE: Well all the parts finally got here...... posted by vinnie2 on December 3, 2016 at 04:16:17:
I realized during the night that I had forgotten to warn you that the 560 uf caps develop a 25 to 30 volt charge that is not dissipated. I have placed a 1 meg resistor across the terminals which I presume will not harm operation of the AC unit but will be safer.
From what I understand, the most accurate way to measure the voltage is with a scope. I suspect your Fluke will be more accurate than either of my DMMs, but my two DMMs (EdTech EX205T and Harbor Freight $24 model) each measure close to each other. GK-71 tubes are cheap.
I am currently rebuilding my amp for the third time and hope to have it back in action later today or tomorrow.
ray
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- a warning - RayP 04:33:53 12/03/16 (12)
- RE: a warning - vinnie2 06:02:05 12/03/16 (5)
- RE: a warning - Palustris 10:59:01 12/03/16 (1)
- RE: a warning - vinnie2 12:03:33 12/03/16 (0)
- diodes - RayP 06:44:59 12/03/16 (2)
- RE: pull some windings off the smaller choke and - deafbykhorns 10:36:15 12/04/16 (0)
- RE: diodes - vinnie2 08:30:17 12/03/16 (0)
- thermistor - RayP 04:49:11 12/03/16 (5)
- RE: thermistor - vinnie2 06:03:42 12/03/16 (4)
- RE: thermistor - RayP 06:32:00 12/03/16 (3)
- RE: thermistor - vinnie2 08:34:09 12/03/16 (2)
- RE: thermistor - RayP 09:17:25 12/03/16 (1)
- RE: thermistor - vinnie2 10:18:22 12/03/16 (0)