In Reply to: RE: Those solder joints on the resistors and cap need to be redone..... posted by jk on November 29, 2016 at 08:16:02:
I recommend using a solder wick or sucker to draw off the old blobs. Clean & use small amount flux for new solder job.You need a small iron point for doing pads.
Good luck!
Edits: 11/29/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Those solder joints on the resistors and cap need to be redone..... - FenderLover 11:05:53 11/29/16 (0)