In Reply to: RE: ok, so now I am really confused..... posted by Triode_Kingdom on November 20, 2016 at 11:55:39:
I am pretty sure the negative input is not grounded, but i don't think I am going to be able to see anything else the way this thing is put together. Not much room between the board and the bottom. Since it appears there is now not much difference between the two channels sound wise now, I am going to assume for the time being that the switchers are ok and try to get the 26 and the preamp squared away and then listen again. I have attached two scope shots. The first was taken at the outputs of the switcher with a 1x probe, volts/div 50m, sec/div 10us. The second shot was taken with at the outputs of my filter, volts/div 20m, sec/div 10us, 1x probe.
Edits: 11/20/16 11/20/16 11/20/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: ok, so now I am really confused..... - vinnie2 13:45:44 11/20/16 (15)
- RE: Output chassis ground - gusser 09:00:14 11/21/16 (1)
- RE: Output chassis ground - Tre' 09:45:36 11/21/16 (0)
- RE: ok, so now I am really confused..... - Triode_Kingdom 20:23:54 11/20/16 (12)
- RE: ok, so now I am really confused..... - vinnie2 04:03:49 11/21/16 (11)
- Switcher Filter - Triode_Kingdom 09:05:29 11/21/16 (10)
- RE: Switcher Filter - vinnie2 13:14:19 11/21/16 (9)
- RE: Switcher Filter - Triode_Kingdom 13:43:49 11/21/16 (8)
- RE: Switcher Filter - vinnie2 15:48:22 11/21/16 (1)
- Hum Pot - Triode_Kingdom 18:17:10 11/21/16 (0)
- RE: Switcher Filter - vinnie2 13:55:40 11/21/16 (5)
- RE: Switcher Filter - Triode_Kingdom 14:04:39 11/21/16 (4)
- RE: Switcher Filter - vinnie2 15:47:00 11/21/16 (1)
- RE: Switcher Filter - Triode_Kingdom 18:28:52 11/21/16 (0)
- let's hope he doesnt have a cat -nt- - elblanco 15:32:57 11/21/16 (1)
- Don't laugh! - Triode_Kingdom 18:33:37 11/21/16 (0)