There are times I need a single section equivalent of the 'SL7. The 6AQ7 looks like a good candidate, but I recall online posts where someone claimed that the operating conditions aren't the same. Looking at the data sheets, the two appear identical. Is there something I'm missing? Anyone here used the 6AQ7?
This post is made possible by the generous support of people like you and our sponsors:
Topic - 6AQ7 VS 6SL7 - Triode_Kingdom 08:16:16 10/24/16 (12)
- Dont forget about the 7-pin miniatures - Alpha Al 18:32:59 10/25/16 (0)
- RE: 6AQ7 VS 6SL7 - Palustris 14:38:20 10/25/16 (0)
- If it looks like a duck, quacks like a duck - Chip647 07:32:14 10/25/16 (9)
- Verrückte ente! - FenderLover 12:07:59 10/25/16 (0)
- RE: If it looks like a duck, quacks like a duck - Triode_Kingdom 07:58:07 10/25/16 (5)
- RE: If it looks like a duck, quacks like a duck - Paul Joppa 12:54:00 10/25/16 (4)
- RC-19 - Triode_Kingdom 15:36:50 10/25/16 (3)
- curiouser and curiouser ... - Paul Joppa 19:33:07 10/25/16 (2)
- RE: curiouser and curiouser ... - Triode_Kingdom 10:30:09 10/26/16 (1)
- RE: curiouser and curiouser ... - Paul Joppa 20:06:25 10/26/16 (0)
- Looks like both half share same heater filament - FenderLover 07:47:14 10/25/16 (1)
- RE: Looks like both half share same heater filament - Triode_Kingdom 08:13:17 10/25/16 (0)