In Reply to: RE: converting to critical L input filters or not ... posted by Tre' on October 9, 2016 at 10:24:35:
I have run a flywheel filter on a SE 45 stereo amp for a few years with no component failure.
The DC load was around 96mA, B+ over 500V since it was a parafeed circuit.
The Triad C56U L1 choke is rated for 2A, it is a robust part.
I also doubled up the rectifier diodes and used motor run caps for C1.
Reports of a "psychoacoustic" effect or something that will make a sound like a guitar effects processor or AM radio by using a flywheel filter in your amp is simply not based in reality , IME.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: peak currents not a major concern for low power SE - deathtube 667 04:10:40 10/10/16 (7)
- RE: peak currents not a major concern for low power SE - Tre' 08:07:43 10/10/16 (3)
- RE: good point ... - deathtube 667 09:37:42 10/10/16 (1)
- RE: good point ... - Tre' 12:06:23 10/10/16 (0)
- RE: peak currents not a major concern for low power SE - Triode_Kingdom 09:18:18 10/10/16 (0)
- Good for you! - Chip647 06:57:42 10/10/16 (2)
- RE: LOL!!! - deathtube 667 12:49:36 10/10/16 (1)
- RE: LOL!!! - Chip647 15:16:58 10/10/16 (0)