In Reply to: RE: Let me try again posted by Sidewinder on September 28, 2016 at 18:12:36:
That schem is not for the amp I am working on, it is just similar and it was handy. But to answer your question, on that schem it would come from where the B+ goes to the lower half of the output trans on the bottom right of the schem. It then is taken to the plate resistors of the 26's, which according to what Tre' is saying should have another resistor in front of them to reduce the B+ down to the B++ that is needed for the plate voltage. I am going to make that change tomorrow and see how that works out. I think it would help explain the trouble i was having trying to the plate volts and plate current to design levels. We'll see what happens.
The more knowledgeable members of the forum will always have my gratitude for their willingness to share their knowledge with those of us who struggle through the valleys while they leap from mountain top to mountain top.
Edits: 09/28/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Let me try again - vinnie2 18:26:38 09/28/16 (0)