In Reply to: Let me try again posted by Tre' on September 28, 2016 at 10:11:58:
Ok, I am confused. What does the plate resistor do if it's not there to adjust the plate voltage? That is what I have been doing with it. The 22k resistor shown in my schem is both plate resistor and drop resistor in one by your definitions. There is nothing else to show.
The b+2 is just taken from the b+ supply to the plate resistors of the 26's where it is reduced to the plate voltage I need for the 26 (this schem does not show it). I get the feeling you are going to tell me I have it all wrong again. : )
Let me know if you need me to and I will post a schem of the 26/845 amp. I will have to clean it up a bit and take a picture.
Edits: 09/28/16 09/28/16 09/28/16 09/28/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Let me try again - vinnie2 13:56:49 09/28/16 (10)
- RE: Let me try again - Sidewinder 18:12:36 09/28/16 (1)
- RE: Let me try again - vinnie2 18:26:38 09/28/16 (0)
- RE: Let me try again - elblanco 14:48:49 09/28/16 (1)
- RE: Let me try again - vinnie2 15:31:23 09/28/16 (0)
- RE: Let me try again - Tre' 14:45:09 09/28/16 (5)
- RE: Let me try again - vinnie2 15:26:20 09/28/16 (4)
- RE: building the proven/tested circuits ... - deathtube 667 20:02:02 09/28/16 (3)
- RE: building the proven/tested circuits ... - vinnie2 03:41:50 09/29/16 (0)
- RE: building the proven/tested circuits ... - Tre' 20:30:43 09/28/16 (1)
- RE: building the proven/tested circuits ... - vinnie2 03:43:08 09/29/16 (0)