In Reply to: RE: balancing the plate volts and plate current posted by Tre' on September 28, 2016 at 09:57:06:
If you can see the changes I made to your schematic you will see that the 1.5k resistors are the voltage drop resistors and the 47uf caps are the decoupling caps and the 22k resistors are the plate resistors.When you want to change the plate voltage you should change the value of the voltage drop resistors, not the value of the plate resistors.
I'm not sure what your note "B+ 2 supplied from terminal strip that has reduced B+" means.
The only thing that should be reducing the B+ is the drop resistors. That is to say, the full B+ voltage should be feeding each drop resistor and those drop resistors should be whatever value they need to be to give the voltage that you want feeding the plate resistors, and by extension, the plate voltage you want.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
Edits: 09/28/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Let me try again - Tre' 10:11:58 09/28/16 (11)
- RE: Let me try again - vinnie2 13:56:49 09/28/16 (10)
- RE: Let me try again - Sidewinder 18:12:36 09/28/16 (1)
- RE: Let me try again - vinnie2 18:26:38 09/28/16 (0)
- RE: Let me try again - elblanco 14:48:49 09/28/16 (1)
- RE: Let me try again - vinnie2 15:31:23 09/28/16 (0)
- RE: Let me try again - Tre' 14:45:09 09/28/16 (5)
- RE: Let me try again - vinnie2 15:26:20 09/28/16 (4)
- RE: building the proven/tested circuits ... - deathtube 667 20:02:02 09/28/16 (3)
- RE: building the proven/tested circuits ... - vinnie2 03:41:50 09/29/16 (0)
- RE: building the proven/tested circuits ... - Tre' 20:30:43 09/28/16 (1)
- RE: building the proven/tested circuits ... - vinnie2 03:43:08 09/29/16 (0)