RE: balancing the plate volts and plate current

Posted by vinnie2 (A) on September 28, 2016 at 07:27:40

In Reply to: RE: balancing the plate volts and plate current posted by Triode_Kingdom on September 28, 2016 at 06:43:49:

So if I use 10% as the allowable tolerance, it would give me roughly a 95-115 vdc range for the plate volts and 5.4 to 6.6 mA for the plate current. Sounds reasonable. I am within those tolerances, and it sounds good to my ears, so no worries mate, I guess. Thanks TK.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - balancing the plate volts and plate current - vinnie2 05:57:32 09/28/16 (17)

RE: balancing the plate volts and plate current - Tre' 07:49:32 09/28/16 (14)

RE: balancing the plate volts and plate current - vinnie2 09:03:30 09/28/16 (13)

RE: balancing the plate volts and plate current - Tre' 09:57:06 09/28/16 (12)

Let me try again - Tre' 10:11:58 09/28/16 (11)

RE: Let me try again - vinnie2 13:56:49 09/28/16 (10)

RE: Let me try again - Sidewinder 18:12:36 09/28/16 (1)

RE: Let me try again - vinnie2 18:26:38 09/28/16 (0)

RE: Let me try again - elblanco 14:48:49 09/28/16 (1)

RE: Let me try again - vinnie2 15:31:23 09/28/16 (0)

RE: Let me try again - Tre' 14:45:09 09/28/16 (5)

RE: Let me try again - vinnie2 15:26:20 09/28/16 (4)

RE: building the proven/tested circuits ... - deathtube 667 20:02:02 09/28/16 (3)

RE: building the proven/tested circuits ... - vinnie2 03:41:50 09/29/16 (0)

RE: building the proven/tested circuits ... - Tre' 20:30:43 09/28/16 (1)

RE: building the proven/tested circuits ... - vinnie2 03:43:08 09/29/16 (0)

RE: balancing the plate volts and plate current - Triode_Kingdom 06:43:49 09/28/16 (1)

RE: balancing the plate volts and plate current - vinnie2 07:27:40 09/28/16 (0)

Follow Ups

RE: balancing the plate volts and plate current - vinnie2 07:27:40 09/28/16 (0)

RE: balancing the plate volts and plate current

Post a Message!