|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: SE 6V6 triode : effect of plate to plate feedback ... posted by deathtube 667 on August 26, 2016 at 06:02:17:
Hi DT, why not use pentode mode for the 6v6 you would have 5watts output? I built a 6l6/6v6 amp of the RH type which uses 6sl7 input/driver tube which is a plate to plate feedback circuit. I used a 200k plate to plate resistor. My operating voltages were higher than yours at 250v on the anode of the 6v6.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: SE 6V6 triode : effect of plate to plate feedback ... - DAK 15:51:21 08/27/16 (1)
- RE: SE 6V6 triode : effect of plate to plate feedback ... - deathtube 667 14:22:27 08/28/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]