In Reply to: RE: SE 6V6 triode : effect of plate to plate feedback ... posted by dave slagle on August 27, 2016 at 05:51:06:
For max power out, a scope probe is hooked up across a load resistor on the OPT secondary.
I run a 1KHz test signal from my soundcard into the amp and look at the point where the waveform clips, then back off until the sinewave looks undistorted.
I also have a true RMS voltmeter across the load resistor to record the AC signal voltage and use the typical ohm's law equation for power.
As for why the THD% is lower with local FBK than non-feedback version, that follows every SE pentode class circuit I have ever tried building.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: SE 6V6 triode : effect of plate to plate feedback ... - deathtube 667 07:36:07 08/27/16 (3)
- RE: SE 6V6 triode : effect of plate to plate feedback ... - dave slagle 09:09:31 08/27/16 (2)
- RE: SE 6V6 triode : effect of plate to plate feedback ... - deathtube 667 10:42:55 08/27/16 (1)
- RE: SE 6V6 triode : effect of plate to plate feedback ... - dave slagle 06:36:41 08/28/16 (0)