|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: What about a switch on the first capacitor? posted by drlowmu on August 19, 2016 at 10:00:00:
If i make C1 switchable in the circuit, i can go to LCLC for my lower voltage SE amps and switch in C1 for the PP amp. Here is a photo of the ps. The PT is on the left, L1 is the big can in the back right, L2 is the smaller trans on the right. The caps in the middle are ASC 100uf x 370vac oil caps. I would add the 5uf oil cap under the chassis. regards, Dak
Edits: 08/19/16 08/19/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: The PS is already built - DAK 11:06:19 08/19/16 (8)
- RE: The PS is already built - drlowmu 08:11:44 08/20/16 (4)
- RE: The PS is already built - DAK 09:29:34 08/20/16 (3)
- RE: The PS is already built - drlowmu 10:34:11 08/20/16 (2)
- RE: - DAK 12:57:22 08/20/16 (1)
- Pins 4 or 6 - drlowmu 13:22:14 08/20/16 (0)
- RE: The PS is already built - FenderLover 17:58:59 08/19/16 (2)
- RE: Yes that is true. nt - DAK 18:13:39 08/19/16 (1)
- RE: Yes that is true. nt - FenderLover 18:36:38 08/19/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
