In Reply to: RE: current hogging in a 2 tube rectifier ps posted by DAK on July 28, 2014 at 13:25:41:
OK, I see that what you're doing is identical to the Scott, other than the CT for the filament winding and parallel filaments. There's no problem paralleling the anodes within a single envelope. You don't need balancing resistors, they'll just degrade supply dynamics. If it were me, I'd consider copying the Scott schematic in terms of the 30 ohm resistor and first two filter caps. Increasing the second cap to 40uF or so might be beneficial, but only if the power supply sags on extended low-frequency passages.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: current hogging in a 2 tube rectifier ps - Triode_Kingdom 16:19:28 07/28/14 (0)