Tech Square Technical and speculative discussion of amps, cables and other topics.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tech Square ]

---

[ Alert Moderator ]

---

RE: Fixed my "vintage" Proceed remote control

Posted by pictureguy (A) on June 13, 2012 at 10:37:20

In Reply to: Fixed my "vintage" Proceed remote control posted by mr.bear on June 8, 2012 at 11:02:20:

My RF garage door remote had a switch which was a maybe.....or maybe not.
Fixed with a new soldered in switch from RS. Looks awful, works fine.

My other remote hassle is from my ceiling fan. Also RF. Over time, it gets more and more reluctant to work. It has little rubber pads which bridge metal serpantines on a circuit board. This seems to 'clog up'. I've used a pencil eraser in the past, but THIS time I used some Deoxit. Let's hope this is a longer lasting fix.
Parts from Hunter? Good Luck, sucker.

It can be done.
Too much is never enough

This post is made possible by the generous support of people like you and our sponsors:

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---