|
Propeller Head Plaza Technical and scientific discussion of amps, cables and other topics. |
|
|
|
Propeller Head Plaza Technical and scientific discussion of amps, cables and other topics. |
|
In Reply to: Re: Do You guys read the HR AA? posted by john curl on November 17, 2002 at 10:11:01:
One need all three mics, 4133 for low noise on axis curves, 4135 for high accuracy and above 20kHz tests, and 4134 for reverb.Our ears detect a 0.3dB change within a 1/3 octave. That leaves 6 different sounding steps within each of many 1/3 octaves within the normally accepted +-1 dB band. Different sounds galore!
After I have measured and trimmed a loudspeaker system, I allways check with many different pieces of well known music.
If I do not like the balance of the music, I start all over again with measuring and adjusting, until I hit something better sounding...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Good that you have it handy - Ole Lund Christensen 12:33:48 11/17/02 (6)
- Re: Good that you have it handy - john curl 14:07:40 11/17/02 (5)
- Yes, please - Ole Lund Christensen 16:36:08 11/17/02 (4)
- Re: Yes, please - john curl 17:10:05 11/17/02 (3)
- Re: Yes, please - Ole Lund Christensen 00:31:56 11/18/02 (2)
- Re: Yes, please - john curl 17:10:18 11/24/02 (1)
- Re: Yes, please - Ole Lund Christensen 14:30:36 12/03/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
