MagneQuest/Peerless Forum Welcome! Need support, you got it. Or share your ideas and experiences.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ MagneQuest/Peerless Forum ]

---

[ Alert Moderator ]

---

RE: Dowdy Chokes

Posted by mqracing (M) on January 6, 2016 at 15:10:56

In Reply to: Dowdy Chokes posted by deafbykhorns on January 6, 2016 at 13:12:12:

This will be my third attempt to post a reply. Darn cell phones and tablets... pain in the ass. Finally have gone to my desktop to post. Shew.

anyway... stock Dowdy plate choke is gapped for 40 madc and produces approx 125 henries. If gapped for 50 mils the expected L would be approx 100 henries. These come supplied in bell end caps. Weigh approx six pounds each. Stand 3.375" tall.

If you know or can picture the Dynaco Stereo 70 ouput... this guy is about the same size... it just has 3/8ths of an inch less stack.

The BCP-16 grid chokes come in channel frames (steel or brass). they are shirt pocket models--- you can fit two into your shirt pocket. L varies with which core material is chosen. Where (circuit wise) would you be using it?

MSL













Builder of MagneQuest & Peerless transformers since 1989

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---