|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
|
|
|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
|
In Reply to: Got a POT in your Speaker-Level Crossover?... Improve it . posted by drlowmu on January 9, 2017 at 11:56:20:
I've not measured but assume up to a point a single resistance placed "before" a crossover will work without seriously affecting response. It may be limited in useful range compared to the L-pad,
tapped autoformes are less linear than resistors - the little Klipsch size aren't too shabby if the crossover point is high enough
Karlson Evangelist
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE:.. Improve it - how about putting the resistance "before" the highpass? . - freddyi 10:20:56 01/10/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
