|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
|
|
|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
|
In Reply to: RE: If you have a schematic of the original x-over laying around.... posted by EduardG on September 12, 2016 at 22:10:03:
parallel with the 2441 to knock it down 3dB to match the mid base. Just a series coil on the 12 inch in the folded bass bin but wired 180 deg out of phase with the mid horn.
My copy of the schematic had all of the drivers and wiring labeled and with it I would not have to pull things apart in order to decide what changes I might want to make.
Might have to order that Titanium Philips screw driver after all. ;-).
First they came for the dumb-asses
And I did not speak out
Because I was not a dumb-ass
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- IIRC, yes and with a 16 Ohm resisitor in - Ivan303 06:13:11 09/13/16 (4)
- I do not think a paralleled resistor would attenuate - rickmcinnis@dogwoodfabrics.com 11:08:13 09/13/16 (3)
- I think the 16 Ohm resistor (15 ohms in real life)... - Ivan303 16:44:54 09/13/16 (1)
- More.... - Ivan303 07:45:46 09/17/16 (0)
- RE: I do not think a paralleled resistor would attenuate - EduardG 11:18:10 09/13/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
