I am aware of the need for higher efficiency speakers , usually stated as a db. rating , in the high 90's to low 100's . Further , I am aware of the need for a fairly flat impedance curve and a higher average rating in the range of 10 , 12 , 14 ohms etc.
But what measurements depict the ability , of a speaker , to work with the high impedance output of a SET amp ? Am I missing something here ?
Thank you .
saki70
This post is made possible by the generous support of people like you and our sponsors:
Topic - Depicting high impedance capability for SET's - saki70 07:52:25 09/01/15 (12)
- RE: Depicting high impedance capability for SET's - Steve Schell 21:47:16 09/06/15 (0)
- RE: Depicting high impedance capability for SET's - Duke 15:15:20 09/01/15 (4)
- I've been - almost - aware of this issue for a good while - Timbo in Oz 15:13:38 09/03/15 (0)
- One of the few! - Paul Joppa 20:51:46 09/01/15 (2)
- RE: "Not many do this..." - Ivan303 07:16:07 09/02/15 (0)
- RE: One of the few! - saki70 06:58:03 09/02/15 (0)
- RE: Depicting high impedance capability for SET's - Paul Joppa 14:42:51 09/01/15 (5)
- RE: Depicting high impedance capability for SET's - fred76 06:47:47 09/03/15 (4)
- RE: Depicting high impedance capability for SET's - bwaslo 16:26:14 09/03/15 (1)
- RE: Depicting high impedance capability for SET's - fred76 21:27:54 09/03/15 (0)
- RE: Depicting high impedance capability for SET's - Paul Joppa 15:34:54 09/03/15 (1)
- RE: Depicting high impedance capability for SET's - fred76 21:20:39 09/03/15 (0)