Home High Efficiency Speaker Asylum

Need speakers that can rock with just one watt? You found da place.

RE: Altec 288 centering

i have over the last 30 yrs seen sooo many non centered but not shifted or touching the body,as long as there is enough room for movement, the movement is so tiny its hard to even see with the naked eye
mark with a sticker or sharpie the location and point it close to the sky ,many reasons for this if there is dust it will fall down any gunk from vc heat will also end on the wider side ,gravity is your friend.

just make sure its clean as hell using card stock, masking tape and a air duster

use a paper shim to make sure the outside edge is close to the body as acceptable and then tighten to avoid vc rub.
are you using original dphrams or after market,
i use 288g and 288c on 1505 tar and 203b respectively


Silence is golden duct tape is silver


This post is made possible by the generous support of people like you and our sponsors:
  Atma-Sphere Music Systems, Inc.  


Follow Ups Full Thread
Follow Ups
  • RE: Altec 288 centering - merdy 08:55:36 08/04/15 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.