Been trying to come up with a decent sounding x-over for 811B Altec horn D250P-8 driver and MCM 55-1220 12" woofer.
The recommended x-over for the D250P-8 is 2nd order 1600Hz, so I used that and a 2nd order 500Hz crossover for the woofer.
I selected the crossover values based on the impedance at the x-over frequencies and used Zobels on the horn & woofer to get a flat impedance curve.
There is a compensation circuit and 12dB series padding resistor on the horn.
The speaker was measured at the listening position ear level.
Been listening to this for a few days and it sounds alright.
Subjectively better than my previous efforts.
This post is made possible by the generous support of people like you and our sponsors:
Topic - 811B D250P-8 : 2nd order x-over graphs ... - deathtube 667 10:02:49 07/27/14 (3)
- RE: 811B D250P-8 : 2nd order x-over graphs ... - John Sheerin 15:09:48 07/27/14 (2)
- RE: Good to see you back here ... - Paul Eizik 08:37:22 07/28/14 (0)
- RE: thanks ... - deathtube 667 15:43:03 07/27/14 (0)