|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: mk3 amps posted by dentaudio on May 29, 2003 at 11:57:17:
I like to run about 45 to 50 mA for each output tube. Therefore if you have retained the original 11.2 ohm cathode resistor this would represent a bias voltage of 1.0 to 1.12 volts. (e.g. 45mA X 2 X 11.2 = 1.0 VDC) so you are within range. if you have changed the value of the cathode bias resistor you cna re-calculate the associated bias voltage from the above formula.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: mk3 amps - Joe Curcio 15:54:01 05/29/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
