In Reply to: RE: Thoughts on red-plating a tube? posted by boeingpilot on May 21, 2015 at 10:43:59:
Check the warranty for the new tubes. Some places give up to 6 months warranty for a bad tube. Also, you should add a 470 Ohm, 1 w resistor in series with each screen grid. That may prevent future red plating caused by screen shorts. I did it and haven't had a tube go red since a few years ago.
I replaced the four power tube and rectifier tube with Japanese ceramic octal sockets in case loose pins are the issue.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Thoughts on red-plating a tube? - Audio Pete 09:51:26 05/30/17 (0)