I am having some problems with my pre-amp.
Some years ago I assembled the Audio Note Pre-amp KIT 2.0, it was initially connected to a pair of Jeff Rowland Model 1 amplifiers, and worked fine. Later, I bought a BAT VK-55SE amp and it has been working fine for several months.
Today I replaced the BAT for one of the Rowland and every time I turn the amp on it instantly turn itself off, some kind of protection circuit I guess. When I connected directly my DAC (it has a volume control) to the Rowland, it works perfectly.
So, I disconnected the AN pre-amp from everything but the AC cable and I measured up to 2.0 DC volts from the outputs. I think it is triggering the Rowland protection circuit ???
Is it normal to have DC current from a Pre-amp output ? Why the BAT amplifier works ?
I appreciate any help.
Thanks
This post is made possible by the generous support of people like you and our sponsors:
Topic - Pre-Amp Kit 2.0. DC in Output, Help - J Corner 17:27:53 01/13/14 (8)
- RE: Pre-Amp Kit 2.0. DC in Output, Help - Wojciech 08:34:27 01/18/14 (0)
- RE: Pre-Amp Kit 2.0. DC in Output, Help - xaudiomanx 15:24:22 01/15/14 (1)
- RE: Pre-Amp Kit 2.0. DC in Output, Thank - J Corner 15:45:15 01/17/14 (0)
- RE: Pre-Amp Kit 2.0. DC in Output, Help - Vincin 01:36:26 01/14/14 (4)
- RE: Pre-Amp Kit 2.0. DC in Output, Help - J Corner 15:46:27 01/17/14 (0)
- RE: Pre-Amp Kit 2.0. DC in Output, Help - garymuffley 13:31:48 01/16/14 (0)
- RE: a little more Help - J Corner 01:39:37 01/15/14 (0)
- RE: Pre-Amp Kit 2.0. DC in Output, Help - J Corner 06:56:28 01/14/14 (0)