|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Dynaco MKIII tube amp posted by Palustris on January 5, 2017 at 09:52:02:
It would be great to be able to have an all polypropylene capacitor power supply, but you'd need a lot of room for that. IMO, low ESR discrete electrolytics are not bad - the Authenticap multisection cans used in the refresh of these Mark IIIs are stuffed with discrete, low ESR electrolytics. If the Atoms are of an appropriate voltage rating, then they could be fine for a while to come - I think it also depends on how old they are to begin with.
Edits: 01/05/17 01/05/17 01/05/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Dynaco MKIII tube amp - petercapo 10:34:26 01/05/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
