|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Too much noise? posted by Kal Rubinson on December 22, 2016 at 19:23:31:
I'm not disagreeing with you , only passing on my experiences , we have only listened to class-D on ESL's , ribbons, ribbon hybrids and here they fail in comparison to good class-A A/ab Amps, I'm technically aware they would sound differently at 8 ohms with conventional higher sensitivity speakers and had looked into modifying the output inductor for low Z operations.
Frankly the lack of proper heatsinking and limited PSU would have to be addressed for that also, imo opinion they are currently best as 8 ohm amplifiers.
Regards.
Edits: 12/23/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Too much noise? - A.Wayne 08:16:25 12/23/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
