Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: I have a fully upgraded LP1 in my system, but I need help with adjusting resistance. posted by alaskahiatt on September 14, 2016 at 10:12:33:
The idea of the sockets is to allow you to insert the resistors without soldering them in.
The earlier link in this thread will take you to an owner's manual you will need to figure out how to handle amps with a different input impedance.
According to the manual, using an amp that is appreciably lower or higher in input impedance will change the xover point either up or down, depending on that impedance. The resistor (or capacitor) is to compensate for that difference.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I have a fully upgraded LP1 in my system, but I need help with adjusting resistance. - louie3 10:49:59 09/14/16 (2)
- Thanks very much. That's too easy. My system pictured is in my - alaskahiatt 11:42:26 09/14/16 (1)
- RE: Thanks very much. That's too easy. My system pictured is in my - louie3 12:34:55 09/14/16 (0)