Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Dahlquist DQ-LP1 Electronic Crossover posted by louie3 on September 14, 2016 at 08:10:36:
I decided to leave the factory setting, as it was so close to achieving the crossover point that I desired. The other reason I left the factory setting alone was that I am not sure how to install the resistors in the small tubes provided in the circuit(arrow in picture-not my unit).
Do you solder the added resistors into the tube or just push the resistor leads into the tube. The latter would seem to be a bad choice. Thanks in advance.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I have a fully upgraded LP1 in my system, but I need help with adjusting resistance. - alaskahiatt 10:12:33 09/14/16 (3)
- RE: I have a fully upgraded LP1 in my system, but I need help with adjusting resistance. - louie3 10:49:59 09/14/16 (2)
- Thanks very much. That's too easy. My system pictured is in my - alaskahiatt 11:42:26 09/14/16 (1)
- RE: Thanks very much. That's too easy. My system pictured is in my - louie3 12:34:55 09/14/16 (0)