Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Connections Question posted by Mike 371 on August 5, 2016 at 13:33:18:
I found it in the advanced section of the manual. I recommend you read the manual thoroughly. There are crossover settings and set the receiver to operate at 5.1, cross the Kefs at 80 and the center and rears at 120 to start and go from there. Also if the Kefs are four ohm use the Onkyos 6 ohm setting. Good luck.
ET
"If at first you don't succeed, keep on sucking till you do suck seed" - Curly Howard 1936
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Connections Question - Awe-d-o-file 17:37:52 08/05/16 (1)
- RE: Connections Question - Mike 371 12:22:25 08/14/16 (0)