|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Bass performance tubes vs. solid state part 2 posted by George S. Roland on January 7, 2015 at 11:57:38:
Pretty sure that's room-related. Electrostatics and dynamic drivers have very different room interactions, the latter generally affected much more by boundary reflections and room modes. Try moving the B&Ws around a bit - even a few inches can make a big difference. If there's a bad room mode, you might not be able to get rid of it.
The amp power (lack of) is probably contributing, but I'd guess the room interactions are more important.
Cheers,
Dunc
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Bass performance tubes vs. solid state part 2 - dunkyboy 15:02:41 01/23/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
