|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Cool running Krell KSA 100 posted by samman11 on October 28, 2014 at 10:40:15:
I think the early "fan amps" didn't feel nearly as hot as the later heat sink only designs, but they should still feel pretty warm.
I've attached a link with the best description to biasing that I could find.
Would say that I'd probably go closer to 500 mV than the 325 mV suggested. Believe the factory spec was 600 mV.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Certainly worth making sure bias is same between channels... - David S. 07:16:12 10/29/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
