|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
I plan on getting the Placette volume controller sometime later this year. Mainly for my newer solid state setup. However, I have a question:
I have one vintage setup that I use most of the time. Can I also use the Placette volume control as a line attenuator without the "bad" side effects of signal rolloff (seems to be mostly treble in my case) and loss of dynamics?
Or would I hear still hear some of these effects even with the Placette? I've tried various passives. Even some high end controls. And the results are always the same to varying degrees. Heck if it works I'll get two!!
charles
This post is made possible by the generous support of people like you and our sponsors:
Topic - Source line attenuator question - Placette - airtime 06:44:26 07/22/14 (12)
- RE: Source line attenuator question - bare 19:29:55 07/22/14 (0)
- RE: Source line attenuator question - Placette - georgehifi 14:38:06 07/22/14 (0)
- RE: Source line attenuator question - Placette - AbeCollins 11:08:27 07/22/14 (8)
- I have yet to hit midway on mine. - Jack G 05:02:53 07/23/14 (0)
- Source line attenuator - airtime 16:38:57 07/22/14 (6)
- What's the difference ? - AbeCollins 18:37:03 07/22/14 (5)
- RE: What's the difference ? - airtime 07:49:16 07/23/14 (4)
- RE: What's the difference ? - AbeCollins 08:21:42 07/23/14 (3)
- RE: What's the difference ? - airtime 08:38:44 07/23/14 (2)
- RE: What's the difference ? - AbeCollins 08:43:15 07/23/14 (1)
- Excellent nt - airtime 09:01:58 07/23/14 (0)
- RE: Source line attenuator question - Placette - Jack G 08:34:31 07/22/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
