Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
I opened the amplifier and saw the failure - it's a grey resistor located on the left channel driver PC board. There are two such resistors on the left of the V5 5687 tube position and two on the right of the V6 5687 tube position. The leg of such resistor got loose. Unfortunately, I cannot make a picture.
My question is: would it require a great technical skill to solder the leg back to the PC board? Or the entire board should be removed? Would it require a special thin soldering iron?
Thanks in advance.
This post is made possible by the generous support of people like you and our sponsors:
Topic - NAF amp failure update - Tubers 15:33:14 08/09/12 (8)
- RE: NAF amp failure update - henrybasstardo 11:57:01 08/10/12 (0)
- Here's a video - Vic D 07:15:47 08/10/12 (0)
- RE: NAF amp failure update - Jerry P 05:51:08 08/10/12 (2)
- RE: NAF amp failure update - pars 09:33:05 08/10/12 (1)
- RE: NAF amp failure update - Jerry P 11:26:39 08/10/12 (0)
- RE: NAF amp failure update - amioutaline? 18:36:49 08/09/12 (2)
- RE: NAF amp failure update - Tubers 21:08:52 08/09/12 (1)
- RE: NAF amp failure update - Frihed89 23:11:08 08/09/12 (0)