Home DIY HiFi Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

need help with the ella

hi i was pointed in this direction by zarniwoop who has been very kind in helping out with my problem. before i go further i must caution you that i am a total idiot in electronics - the only reason i took on the ella was to challenge myself, wean myself off 'hi end' kit and equally 'hi end' dealers and learn about this craft and boy do i have a lot to learn :)

so here goes. i completed the kit and was getting weird figures ont he meter which didnt tally with the numbers in the manual. checked wiring and found that chassis ground was not secure and vol pot ground had a bad joint - fixed this and was getting the right numbers save for the last 2 stages.

i rechecked the wiring and as it was suggested that there might be a cold solder joint with the 10ohm/4 watt resistors to ground, i checked this and yes there was and fixed it. the latest readings i got are:

A5 - D5 - 50vdc
A2-A7/B2-B7: 6.19 vac (it was 6.27 last night)
C2-C7/D2-D7: 6.22 vac
pins 7 n 8 on main pcb: 6.22 vac (6.26 last night)
B+: 425 vdc (390 vdc last night)

this is the strange part:
when i put in the 6550s and checked the bias rca, instead of getting .4vdc i was getting 250 mvdc. i stopped here and did not carry on with the other tubes.

question: is the power ground and signal ground connected in this amp? i remember being told that it shouldnt - but i may have heard wrong.

is the centre pin of the bias rca connected to ground?

finally what gives? would appreciate any help

thanks for reading
mikey


This post is made possible by the generous support of people like you and our sponsors:
  Schiit Audio  


Topic - need help with the ella - mikey115 09:31:10 11/28/02 (24)


You can not post to an archived thread.