Message Sort: Post Order or Asylum Reverse Threaded
How best to secure loose tonearm bayonet fitting?
151.228.209.27 |
||
Posted on February 15, 2017 at 10:54:44 | ||
Posts: 217
Joined: February 9, 2007 |
I have a tonearm with a removeable headshell, where the connection between the detachable headshell and its bayonet mounting is good/secure, but where the bayonet mounting itself is a little loose within the tonearm tube. I have tried tightening up the set screw on the underside of the armtube but, with not very much pressure at all (certainly less than would be experienced when just carefully removing/re-fitting the headshell), the bayonet housing becomes loose again. I want to secure the bayonet housing properly, with a slow curing bond of some sort which would allow me to set correct re-alignment of the headshell before it goes off, and was wondering what others would suggest to use in order to do it? I had toyed with the idea of adding a second set screw but fear the mess I might make of the drilling process and the stress it would put on the arm bearings, so suggestions for an alternative fix would be appreciated. |