Radio Road

Which tuner to get and getting the most from it. Thank God, for the radio!

Return to Radio Road


Message Sort: Post Order or Asylum Reverse Threaded

Accuphase 101 T tuning

184.174.134.53

Posted on August 15, 2016 at 15:48:32
Thanks for all the replies about leaving my 101 T on all the time.

The reason I asked about this is that when I turn the tuner back on in the morning, I have to re-tune it. If I leave it on its fine.

In order to re-tune I have to make sure the volume is down because of interstation noise, and the tuning is so sensitive.

Will an alignment solve this problem? Or is this typical?

Thanks

 

Hide full thread outline!
    ...
RE: Accuphase 101 T tuning, posted on August 15, 2016 at 18:03:10
fredtr
Audiophile

Posts: 1987
Location: Phoenix
Joined: January 4, 2005
Not typical, I had two of them, neither exhibited that problem.

Alignment alone, probably won't fix it. It sounds like a thermal problem, a component changing value as it warms up. You might be able to identify the component with cold spray, but you will need to spray very little and use shields (cardboard is fine) so that you can cool one component at a time. Tuners with thermal tuning problems are more difficult to isolate the component than other problems/equipment because the spray cools too much and condenses moisture which can also detune temporarily.

If you decide to live with it, and you mainly listen to the same station, tune the station in warmed up, then turn the tuner on earlier than the other equipment and let it warm back up.

 

RE: Accuphase 101 T tuning, posted on August 16, 2016 at 07:32:40
Thanks,

Yep turning it on early is a solution, but I do listen to more than one station.

Another solution is two tuners in the system, leaving the Accuphase on the classical music station.

My little (really) Meridian 104 is the probable candidate for the other station since that's mostly used for news in the morning and at the end of the day.

 

I'm confused, posted on August 16, 2016 at 08:59:31
1973shovel
Audiophile

Posts: 10117
Location: Greenville SC
Joined: February 25, 2007
What's wrong with lowering the volume control a bit, temporarily pushing in the muting button while changing stations, or both?

Not that there's anything wrong with having two tuners hooked up!

 

RE: I'm confused, posted on August 16, 2016 at 09:07:36
I have tried what you suggest, but the problem is that sometimes it is hard to tell when the station is tuned, even using the meters, so I have to hear the station.

Anyway, looks like two tuners are probably best, unless I can find someone to do a rebuild on the Accuphase.

I sent an email to Accutech, but have gotten no response so far.

 

RE: " I have to hear the station", posted on August 17, 2016 at 05:11:57
1973shovel
Audiophile

Posts: 10117
Location: Greenville SC
Joined: February 25, 2007
I agree, I'd never be able to tune just by watching the meter(s) either. I simply turn the volume down to a point where the between channel noise isn't overwhelming, tune in the station, then turn it back up to where I'm going to listen.



 

RE: I'm confused, posted on August 17, 2016 at 05:29:34
FWIW...I got a reply from Accutech and an alignment is not expensive at all, other than the trouble to box up the tuner and shipping cost.

But from the comments and listening, it sounds as though I may not need an alignment, but probably some rebuilding on some or all of the boards.

As good as the tuner sounds, I am wondering if the thing to do is to just listen to it and not worry.

 

RE: Accuphase 101 T tuning, posted on August 17, 2016 at 08:15:57
fmak
Audiophile

Posts: 13158
Location: Kent
Joined: June 1, 2002
You should realign using a FM signal generator, or get it done for you.

 

RE: Accuphase 101 T tuning, posted on August 17, 2016 at 12:19:59
fmak
Audiophile

Posts: 13158
Location: Kent
Joined: June 1, 2002
You can quite easily realign yourself by getting the service manual.

 

Page processed in 0.024 seconds.