K&K Audio / Lundahl Transformers

Welcome! Need support, you got it. Or share youe ideas and experiences.

Return to K&K Audio / Lundahl Transformers


Message Sort: Post Order or Asylum Reverse Threaded

46 IT 46

97.83.44.80

Posted on March 21, 2016 at 13:53:08
jdg123
Audiophile

Posts: 6
Location: N, Michigan
Joined: May 23, 2015




I am attempting to make an all DHT SET. I require very little power or gain, I'm looking for something very simple, Clean and full of "tone".

I'm not sure I understand interstage transformers so I supplicate myself before the master... Does this arrangement make sense/will this work?

 

Hide full thread outline!
    ...
RE: 46 IT 46, posted on March 21, 2016 at 18:24:37
KevinC
Manufacturer

Posts: 2984
Location: NC
Joined: April 19, 2001
There's nothing wrong with the proposition diagrammed above. With a 5K:8ohm output transformer, and two 46 gain stages, you will achieve a gain of about 8dB.

Given the plate impedance of the tube (something like 2400ohms) you could get good results from either the Lundahl LL2753/25mA (1:1) or the shown Lundahl LL2746/30mA (1:2). The Lundahl LL1663/30mA (5K:8ohms) would be my choice for output transformer.

With the output stage cathode resistor shown the IT secondary lead labeled "BIAS" will require a positive voltage applied or the output tube will be cut off. You could use a smaller value cathode resistor and then ground that secondary lead.

Kevin Carter
K&K Audio
www.kandkaudio.com

 

RE: 46 IT 46, posted on March 29, 2016 at 05:55:07
jdg123
Audiophile

Posts: 6
Location: N, Michigan
Joined: May 23, 2015



Thank you very much for taking a look! I have taken your suggestion to heart. I already have a James 6123 output or I'd be looking to make the new amp all Lundahl. I have more to work out but I'll come back and post here when I have a proper build to report on. And I'll be needing the LL2746 for sure!

 

Page processed in 0.022 seconds.